MEAM.Design - MEAM 101 - MOVE


Timeframe

06S - 08S


Objective

  • Make something awesome. Then make it move.


Constraints

  • Your total model material must be less than one cubic inch.
  • Your total support material must be less than one cubic inch.
  • You will only be printing one "part".
  • Be careful about tiny features! Your smallest features should be at least 0.021".
  • The layer resolution must be set to 0.007 inches.


Process and Submission

  • Save your part/assembly as an STL from SolidWorks. Open your STL file in Catalyst. Change the printer to the Dimension Elite. Set the layer resolution to 0.007". Properly orient the part. Process the STL. Check the layers. Add the part to the pack. Check the material usage. DO NOT CLICK PRINT.
  • Go find the CMB file that has been created next to your STL file, and rename it as MOVE-PennKey.cmb.gz.
  • Save a JPG of your SolidWorks part/assembly and rename it as MOVE-PennKey.jpg (where PennKey is the part before the @ sign in your school email address).
  • Failure to name your files using the convention above will result in an incomplete project.
  • Upload both the CMB and JPG files to the Canvas assignment.